Monster Can Gear Shifter (1 Inch Pipe
$5.00
One-time purchase·
HiddenMark Protected
Protected by HiddenMark — If shared illegally, the source is traceable.
3D printable filler for a 16 Oz monster can. Could be used for a gear shifter or for something else. This version comes with a hole designed to fit 1 inch piping (version with no hole available). PLA works just fine, recommend using a low infill to save filament. Just cut the bottom of the can off and insert the filler. Use an epoxy or sealant to secure the can around the filler. Some form of a fastener may be necessary to cover a roughly cut edge on the bottom of the can....
File Information
3D Model TypeSTL
Dimensions63.0 × 63.0 × 146.4 mm
Polygons556
Mesh check Watertight
UploadedOct 20, 2026
Intended use3D printing
0 likes0 downloads
Support & Refunds
If you experience issues with this model, contact the creator directly for support. Refunds are available within 7 days of purchase if the file is defective or not as described.
