Monster Can Gear Shifter
$5.00
One-time purchase·
HiddenMark Protected
Protected by HiddenMark — If shared illegally, the source is traceable.
3D printable filler for a 16 Oz monster can. Could be used for a gear shifter or for something else. PLA works just fine, recommend using a low infill to save filament. Just cut the bottom of the can off and insert the filler. Download and edit the file to add a custom size hole to the bottom of the filler or drill manually after print (version designed for 1 inch piping available). Use an epoxy or sealant to secure the can around the filler. Some form of a fastener may be necessary to cover a roughly cut edge on the bottom of the can....
File Information
3D Model TypeSTL
Dimensions63.0 × 63.1 × 146.4 mm
Polygons372
Mesh check Watertight
UploadedOct 20, 2026
Intended use3D printing
0 likes0 downloads
Support & Refunds
If you experience issues with this model, contact the creator directly for support. Refunds are available within 7 days of purchase if the file is defective or not as described.
